New Arrivals

Sold SINGLE. Includes a three-way (on-off-auxiliary) switch with about 8" of wire attached. Additional wire and connectors (not included) may be ne...

Replaces OEM part # P54-6069-100 (driver's side) or P54-6069-100R (passenger's side)

Sold SINGLE. This light plugs into the existing OEM plug, which powers the amber marker/turn signal function. There is an additional hot wire, conn...

Fits Kenworth T680, T700, W990, and T880. Sold SINGLE. Uses the OEM plug for the marker/turn signal function. There is an additional male .180 bull...

Fits Kenworth T680 and T700, as well as Peterbilt 567 and 579. The Amber function is powered by the original OEM plug, and there is a separate hot ...

Sold SINGLE. Includes stainless steel ring used for mounting this as a flush mount light. This is a 3-wire light - functions as a marker and a turn...

This light features three bullet plugs - one ground, one hot to power the red side, and a second hot to power the blue side. Both colors are a sing...

Flush mount, high power LED with 11 flash patterns, selectable for synchronized and alternating. Slim profile and surface mounted for easy installa...

This bullseye/bullet rubber grommet is perfect for replacing only that single rubber piece instead of the entire light. It is 3/4" and fits most bu...

Measures 3-1/2" diameter across the light face, at the widest point. Overall length is 16-1/4", with 7-15/16" between mounting holes (measured cent...

The trucking industry has been waiting many years for an under glow lighting solution just like this one! Trux Accessories' Glow Strip under-glow l...

Measures 4" wide across the light face, at the widest point. Overall length is 10-3/4", with 9-1/4" between mounting holes (measured center-to-cent...

One side of this light is amber, the other red. There are diodes on both outside-facing ends, so the same light can be used for either driver's sid...

This light's overall measurements are approximately 1" by 1-1/4", including the chrome bezel. This light features three bullet plugs - one ground, ...

This light replaces the turn signal on the side of Peterbilt 379 dual rectangular headlight housings. It includes four wires - the three standard w...

One side of this light is amber, the other red. When the Dual Revolution wiring is activated, both sides burn blue. Lenses are CLEAR when off. The ...

This light is a stop/turn/tail and an auxiliary light, all in one housing! Using the standard three-prong offset plug, it will light up red and fun...

This roll of flexible interior strip lighting can be cut every 3 diodes (2" spacing) and new 18 gauge wires (not included) soldered to the ends. So...

1/2" wide by 17" long. Mounts using supplied 3M double-stick tape. Powered by three .180 male bullet plugs - one ground, one hot to power the amber...

1/2" wide by 17" long. Mounts using supplied 3M double-stick tape. Powered by three .180 male bullet plugs - one ground, one hot to power the amber...

This light is a stop/turn/tail and an auxiliary light, all in one housing! Using the standard three-prong offset plug, it will light up red and fun...

Fits most trucks with the 4" x 6" dual rectangular headlight setup, including Peterbilt 379, Kenworth W900, and Freightliner Classic. Sold SINGLE.H...