Best Sellers

Fits speedometer and tachometer gauges on 2006 and newer Kenworth dashes. Pushes down into the inset gauge. Includes optional double-stick mounting...

This 18" x 18" oversize load flag comes pre-mounted to a 3/4" diameter wooden dowel. The dowel is 36" (3 feet) long.This is a simple, cheap solutio...

High quality polycarbonate lens with epoxy sealed circuit board. 12V DC, 1157 plug, easy plug-in design. Also fits 1994-2008 Kenworth T300 and T3...

These small Panelite-style marker lights are often found on air cleaner light panels, but they're also great for fender guards, visors, and even bu...

Delphi/weatherpack style plug on one end, approximately 6" of plain wires on the other end. Sold SINGLE.

This chrome pointed hubcap comes with a "spinner" style knock-off already attached, so it's ready to pop onto your truck. The spinner can be custom...

Includes heavy duty mounting bracket. Measures 5" diameter.

1.5" diameter. Sold SINGLE.

This two-piece (front and back) steering column cover does not include mounting hardware. Imported.

Many truckers are converting their trucks to an all-LED setup. One advantage LEDs have over incandescent lights is that they present an opportunity...

1/4" thick, also measures 6mm thick. Includes foam gasket, only. Plate, light, and hardware are not included. Compatible with Grand General 87142 w...

The red turn signal is a dual-function light. There are three wires, all attached to .180 male bullet plugs.  Includes mounting ring. Sold SINGLE.

This replacement cupholder really amps up the chrome volume of your dash. Whether you use it to hold a big gulp, a bunch of change, or keep it empt...

Watermelon lights and switches sold separately. No wiring included. Compatible with any watermelon style sealed LED or glass lens light assembly. G...

This 20" spring and case also includes an air line clip at one end, with a carabiner at the other end.

Measures 17" (L) x 1" x 1". This is a dual function light - will work as both a marker and a turn signal. Hardwired with three plain wires. See rel...

Our Halo Amber/Red square 59 diode LED turn signal light gives your vehicle the perfect balance of style and function. Featuring 59 diodes, you can...

Fits around the existing cupholder, storage, power plug panel of the center dash. This is a trim piece, not a replacement panel. Tape mount. Manufa...

This universal stainless steel rear center panel includes four "Fleet" Red 4" round 18 diode LED stop/turn/tail lights - CLEAR lens with chrome twi...

Adjusts up to 9" height. Appropriate for all half and full fender applications. Features a single frame-mount bolt for fast, simple installation.So...

Includes driver's and passenger's side trim pieces. Tape mount, manufactured in the USA.

Fits W900, T600, T660, T800 Daylite Door AND NON-Daylite Door models of all year build. Will NOT fit T2000, T680, T880, or W990 models. Includes dr...

These P3 marker lights are perfect for air cleaner light brackets or adding a little sparkle to a small space. The detailed chrome bezel sets this ...

This slick nut cover looks, as the name suggests, like a chrome bullet. It's more rounded than our spike covers, so if you're searching for a look ...

Tape mount - sticks to the existing trim. This is not a full replacement piece. Fits Peterbilt trucks 2006 and newer, including 379, 386, 388, and ...

These simple mudflap hangers will do the job without costing you a lot of money. Perfect for fleets or drivers who break a lot of mudflap hangers! ...

Turning the wheel is made easy with this spinner knob. Made of durable, heavy duty aluminum, its sure to make your wheel-turning experience simpler...

This light requires the use of either a rubber grommet or mounting flange. This light has a built-in two-prong female plug in the back. These light...

These switch nut covers work wonders for adding a little panache to your dash. Use them with our chrome toggle switch extensions for a complete loo...

Mounts using your existing dash screws. Fits older Kenworth dashes.

These are clear lens, four wire lights. Includes thin foam rubber gasket and stainless steel ring, with stainless steel hardware.

This is a single-function 2 wire light.

Sold SINGLE. Universal - fits on any frame! Compatible with Roadworks, Grand General, and Trux Accessories LED or incandescent glass lens watermelo...

Replacement transmission range valve (manifold) with original-style knob, skirt, splitter, and range selector. All ports are 1/16" NPT. Eaton Fulle...

This center cap is a replacement for United Pacific rear axle covers. It will not mount on the rear axle by itself. Sold SINGLE.

This light features a built-in two prong female plug in the back, which powers the red diodes. There is an additional single bullet plug, which is ...

This chrome plastic panel is a replacement for the existing dash panel. Mounts using included clips - no bolts or screws included or needed. See re...

Sold EACH. May not fit newer trucks. We do not have an exact year break for this. Check measurements before ordering! Fits gauges with a diameter o...

This set includes an orange quickmount flag with quickmount connector, mounting bracket, and one replacement flag.

This replacement mirror is heated, only. It is not lighted or motorized. Sold SINGLE.

For easy installation, these "Chopped Look" ventshades are pre-cut to fit around the mirror bracket, rather than forcing you to remove the mirror a...

This chrome plastic piece replaces your existing panel, using the existing hardware. This particular setup has one switch hole at the bottom. Other...

Fits Kenworth W900, T660 and other models 2006 and newer. This is a tape mount, plain stainless steel trim. It fits over the existing dash panel.

Fits Peterbilt 379, 386, 388, and 389 trucks 2006 and newer. Will not fit 379 trucks 2005 and older. Sold SINGLE.Measures approximately 7-5/8" x 5-...

Fits any steering wheel measuring between 17-3/4" and 18" diameter. This steering wheel cover fits TIGHTLY over your wheel, so you may need assista...

These tractor/trailer brake knobs fit many older Kenworth trucks. Not compatible with the more common screw-on type brake knobs. 3/8" Inner Diamete...

You'll love these nuts! Hang them on the back of your trailer, for sure - but we've seen them on duallies, sedans, and plenty of others. You'll lov...