Best Sellers

Measures 3" x 2", with 1-3/4" between mounting holes (measured center-to-center). Hardwired with two male .180 bullet plugs, connected to the back ...

This chrome surround twinkles around the interior handle for your sleeper vents. Fits Peterbilt 379 trucks with Unibilt sleepers, where the existin...

4-3/8" tall. While the original spike nut covers had a flange of more than 1", this one is much shorter - closer to 1/4". This gives an illusion of...

Mounts around the upper center instrument panel, above the speedometer and tachometer gauges. This piece measures approximately 10-1/4" (L) x 1-9/1...

Includes clear glass lens, stainless steel mounting bezel, and a premium foam rubber gasket. This is self-grounding light assembly. The 1156 style ...

Fits Century 1997+, Columbia 2000+, Coronado 2003+.We know that you cringe when you look at the passenger's side of your dash and see so much prett...

Fits Peterbilt truck models 379, 386, 388, and 389 year 2006 and newer. Replaces the stock diagnostic port cover.

Tired of flicking that same old turn signal lever? We think its time for a change. Get this turn signal lever cover for a new look on an old piece.

This adapter features the Grote/Trucklite style light plug on one end, and the more common 3-prong offset plug on the other end.

For 1.5" and 33mm nut covers.

Fits 379, 386, 388, and 389 trucks 2006 and newer. Will not fit 379 trucks 2005 and older.Mounts with silicone (included). This piece must sit over...

These replacement facenuts fit on Peterbilt dashes through 2005.

These replacement face nuts fit on electric switches, but not air. Each pack contains six pieces.

This light requires the use of either a rubber grommet or mounting flange. This light has a built-in two-prong female plug in the back. These...

This switch plate fits around the mirror control switches in many newer Freightliner trucks. Switch not included - this is the chrome cover only. S...

This continuous wire harness uses single female plugs and has 8" of 16 gauge wire between each plug. Approximately 4" of wire will be left on each ...

This light features three bullet plugs - one ground, one marker wire, and one turn signal wire. Requires a 3/4" hole to install. Includes chrome be...

Includes the knob, only. Base, skirt, splitter, and high/low knobs and covers not included. Includes female 1/2" x 13 adapter. Compatible with a 1/...

Replaces the chrome bezel from Grand General Fleet series 4" round flush mount LED lights. This is NOT a cover for a rubber grommet. See related it...

Sold in PAIRS. These tape mount switch covers feature two large holes at the top and bottom, as well as a single smaller indicator light hole in th...

Fits newer Cascadia trucks. If the backs of your door handles are smooth, this cover should fit. These are covers for the front of the handle, only...

The trucking industry has been waiting many years for an under glow lighting solution just like this one! Trux Accessories' Glow Strip under-glow l...

Finish up your steering column cover with this middle, center chrome piece. This covers that final black space that the top and bottom pieces do no...

NOTE: The manufacturer is switching these from sold as single to sold in pairs. Check each color for details.

To install, remove the screw and place the plastic cup as a washer. Replace the screw, then snap the chrome cap onto the plastic cup. Each pack inc...

Each number measures 4" tall. Tape mount. Made from chrome plated steel.

Includes right window surround, left window surround, and center post trim. All pieces are tape mounted. Use rubbing alcohol or similar to thorough...

If there were a vote to determine the MVP of the under-dash area on your Peterbilt, this one would be the winner. With more chrome per square inch ...

This is a 3/16" thick version of our classic stainless steel mounting brackets. Compatible with most pedestal-mount LED or incandescent turn signal...

This flag features our favorite jersey mesh on our dual EZ-hook bungie cord. This is a great temporary safety flag that can be mounted anywhere in ...

This single-piece trim fits around the right-side space for 14 small gauges on your dash. The imitation wood grain matches perfectly with the stock...

Fills in empty rocker switch holes on Kenworth trucks 2006 and newer, including the T660, T800, and W900 models. Sold in PAIRS.

These 8-1/4 diameter drive axle hubcaps are an unusual size. They are generally found on older International and Volvo trucks.

This heavy-duty light mounting flange works best with Maxxima brand lights. It may fit other brands, but some will be too large or too small to fit...

These push-in style bulbs are commonly found in dash gauges, bumper guides, and other areas of the truck. The 360-degree viewing angle makes this b...

Sold in PAIRS. These bulbs have a flat face. See related items for styles with a 360-degree viewing range.

These green LEDs are popular with a lot of our drivers who are looking to really customize a project, whether it's a big truck, hot rod, or somethi...

Fits trucks with 33mm lugnuts. Must have 1/2" of stud threads sticking up from the nut in order for these lugnut covers to catch on the stud.Includ...

This is one half Delphi plug - the male end, attached to about 4" of plain wire ends. It has two prongs inside the housing and fits over the female...

This premium mounting arm is made to be used with Hogebuilt half, full, or half-moon (single tandem) fenders. Hogebuilt fenders installed without t...

This accent is a simple addition to your mudflaps that adds a nice bit of shine! 2" wide. Features welded mounting studs with stainless steel hardw...

This Panelite marker light is longer than the M3 style, but narrower than the M1. It's a nice in-between style with 3 single-function diodes.Featur...

To install, remove the screw and place the plastic cup as a washer. Replace the screw, then snap the chrome cap onto the plastic cup. Each pack inc...

These hangers are simple and economical, but still shiny enough to make the rear end of your truck look great. Specs: Chrome plated. 2.5" bolt hol...

This miniature version of the classic Panelite M1 LED light is great for air cleaner bars, sun visors, and a host of other applications. Their smal...