Products

As the name implies, these Fleet lights are economically priced, but high-quality - perfect for outfitting a large number of trucks without bankrup...

This version of the "Fleet" LED turn signal has a built-in Grote 3-pin plug in the back. This is the round plug with evenly spaced pins, not the mo...

This is a flange mount light - no grommet required. The twist-on chrome bezel hides the mounting holes. Mounting hardware not included. It has a bu...

This is not a grommet mount light. It is a surface mount light, perfect for applications like replacing the load lights in the back of your sleeper...

If you've been patiently awaiting the release of an economy-priced light with the diode count of an expensive one, heeeeeeeeere's Johnny! Sold SING...

This round, pedestal light version of our "Halo" LED turn signal features a high diode count along with the signature glowing outer ring. The outer...

Our Halo Amber/Red square 59 diode LED turn signal light gives your vehicle the perfect balance of style and function. Featuring 59 diodes, you can...

Sold SINGLE.Part of United Pacific's "Glo" series of LED lights.Electrical Built-in 2 prong female plug w/twist-lock plate 12 volt Single function...

This oval tail light is a great way to give your truck a shine boost. The glowing outer ring is accompanied by 6 center diodes, all powered by reli...

Sold SINGLE. Measures 17" long by 1-3/8" by 1". Mounting holes are approximately 16-1/8" apart, measured center to center.Part of United Pacific's ...

What looks like a normal, grommet-mount tail light is anything but! The glowing outer "Halo" acts as a soft but fully-functional marker light, then...

There are three wires, all attached to a .180 male bullet plug. The ground wire operates both the primary and secondary functions. Includes mountin...

The Infinity series has been around for awhile, long enough to gain a lot of fans. We've seen this small version of the light used on a whole range...

Sold SINGLE.Electrical Hard-wired with two male bullet-style plugs, connected to the back of the light by a few inches of wire 12 volt Single func...

Lights sold separately! This product replaces the existing bezel on your Spyder ultra-low profile LED light. It will not fit any other style of lig...

This light has the same optics as a glass lens incandescent, but with the reliable durability of a sealed acrylic housing! Mounts in the same 3/4" ...

The unique "Mirage" series turn signals feature a ring of LED light around the outer edge, with a center "tunnel" visual effect that makes the ligh...

Features: 3-1/2"L x 1-3/4"W x 1"H (3" mounting hole centers) Chrome plastic bezel hides mounting screws. This light is hard-wired...

This extra-large light measures 7-7/8" long by 3-11/16" tall by 1-1/8" deep. It is a dual function light, meaning it can be used as both a marker a...

This is a 196" long red LED, adhesive-mounted flexible strip light. This heavy-duty, commercial-grade light is built for on-highway applications an...

Measures 6-1/2" overall width, 5" overall height. Lights are 3.5" diameter, cab light-style lights. Sold SINGLE. This is a heavy light, so we recom...

Each light functions and both a marker / clearance light and turn signal or auxiliary light. Mounts in a 3/4" diameter hole.

76290, 76291, 76292, 76293, 76294, 76295, 76296, 76297This LED light bar includes a short chrome mounting pedestal. These long, thin lights are per...

This long, thin strip light is perfect for interior or exterior use. It's lightweight and small enough to be mounted with double-stick tape inside ...

Features: 17"(L) x 1-3/8"(W) x 1"(H). 16-1/8" between the two mounting holes. This light is a flush mount style light. Mounting hardware...

9 diodes. Crush proof, 4 different functions. Battery powered - requires 3 AAA batteries (not included).

This light has two wires. The post acts as a ground, so it can be used as a dual-function marker and turn signal. Measures 3" diameter across eithe...

No other components included. This is a replacement glass lens, ONLY.

This small, 3 diode light is perfect for adding a subtle glow to your truck. Great for interior or exterior applications. Functions as a marker, on...

This bullseye/bullet rubber grommet is perfect for replacing only that single rubber piece instead of the entire light. It is 3/4" and fits most bu...

Includes mounting hardware. Sold SINGLE.

This light has completely transparent lenses, with virtually no texture or ribbing. As a result, each individual diode shoots light out like a lase...

This is a dual function light, hardwired with 3 plain wires. One face is red and the other face is amber. Can be used as both a marker and a turn s...

This is a dual function light, hardwired with 3 plain wires. One face is red and the other face is amber. Can be used as both a marker and a turn s...

This unique pedestal light has a nice, low profile - great for mounting on the ends of a bumper or perhaps on a tool box. Each light functions as b...

This stud-mount LED turn signal is a modern favorite. The thousands of tiny reflectors boost the already-powerful diodes, giving you the bright, pi...

This turn signal is very versatile - it's as at home on your fenders, bumper, mirrors, or even tool boxes as it would be anywhere. This light is h...

This light works as a turn signal and a marker light, and is hard-wired with three plain wires. These lights function at 12 volts.

This is a dual function light, hardwired with 3 plain wires. One face is red and the other face is amber. Can be used as both a marker and a turn s...

This is an extremely popular lollipop-style light. Each side has 17 diodes, but the multi-faceted background turns each point of light into dozens,...

This lollipop-style LED pedestal light can be fitted anywhere - bumpers, mirrors, wings, and more. Use it alone, or with help from one of our mount...

Light measures 4" diameter, with a 1-1/2" mounting stud. 2" wide, 5-1/2" overall height. Amber on one side, Red on the other side. Sold SINGLE. See...

Sold SINGLE. Light measures 4" diameter, with a 1-1/2" mounting stud. 2" wide, 5-1/2" overall height.

Sold SINGLE. Stud is ground with two wires - can function as both a marker and a turn signal.

This light has a solid, die cast chrome housing. The post acts as the ground, and it has two plain wires, so it can be set up as a dual-function (m...

Measures 6.1" overall height by 4.2" wide. This light functions as both a marker and a turn signal, and is hardwired with three plain wires. It fea...

One face of this 9" long pedestal light is Amber, and the other is Red. Both lights can be removed and replaced in case of breakage or diode burnou...

This single-post mount fender turn signal features a side reflector and flashy chrome rim. Sold SINGLE.This light is post-grounded with two wires -...